New Layer Defaults
The defaults settings can be set from the Toolbox.
Contents
Brush Colors
This section of the palette contains two large overlapping squares - the one in front is the "Outline Color" (previously called foreground color), the one in back is the "Fill Color" (previously called background color). When you are creating a layer of only one color, the "Outline Color" is always used. When you create a region and an outline simultaneously, the region is given the "Fill Color". The current gradient fill defaults to dynamically between these two colors. Clicking either will bring up the Colors Dialog to select a new color.
In addition to these two controls, there are two smaller controls located in the corners between them.
The arrows on the upper-right side swap the outline and fill colors. 
The two little squares on the lower left reverts the outline and fill colors to their default of black and white respectively.
Brush Size
- If you are using the Draw Tool, this sets the maximum size that the line will be based on pressure sensitivity (on graphic tablet).
- Adjust the size of the Brush Tool
The size of Outline Layers's line is set in the Tool Options Panel
Default Blend Method
Sets the Blend Method for new layers. Defaults to By Layer Default.
Default Opacity
Sets the Amount for new layers. Defaults to 1.00 (Completely opaque)
Current Gradient
Used by the Spline Tool when creating a new Curve Gradient layer. Also used by all Gradient layers as their fill. This defaults to a gradient between the "Outline Color" (previously foreground color) and "Fill Color" (previously background color). Clicking this will bring up the Gradient Editor Dialog
Default Interpolation
Sets the default interpolation of new waypoints. Initially this is set to Clamped.
