Doc talk:Adding Layers

From Synfig Studio :: Documentation
Revision as of 07:01, 4 September 2011 by Ghd (Talk | contribs)

Jump to: navigation, search

thoughts

  • setting colors for a "Gradient Layer" needs to be explained or at least a hint to use the link to the Gradient Tool would be helpful. --Ohoservices 22:30, 16 May 2010 (UTC)
  • add Navigation at the end as well... --Ohoservices 22:30, 16 May 2010 (UTC)


clarifications

  • The doc says: "The key point is that a layer can only modify the data that it gets from directly below it." This may convey to the reader that a layer modifies only a single layer below it. The word 'directly' may be the culprit here. To clarify what the author says, we could add the following sentence: "A layer modifies the data that it gets from all the layers below it. However, if the layers are encapsulated, the word 'all' here applies to all the layers within the encapsulation only." --Ghd 05:01, 4 September 2011 (UTC)