Width Tool/ro
|
Warning! This page contains outdated information. The release of Synfig Studio 0.64.0 introduced new terminology and this translated page needs to be updated according to original English text. You can help updating this page - see instructions here. Thank you! |
ALT-W
Instrumentul de latime a liniei - Width a fost destinat pentru cresterea sau descresterea latimii liniei, ca la desenarea cu un creion pe hartie.
Pentru a modifica latimea unui anumit segment al liniei, selectati stratul de conturul respectiv, mutati mouse-ul deasupra liniei, apasati pe butonul dreapta mouse si mutati cursorul ianinte si inapoi de-a lungul liniei, ca si cum ati ingrosa linia cu ajutorul unui creion. Latimea conturului va creste in locurile in care miscati cursorul. Pentru a descreste latimea, apasati "Ctrl" in timpul miscarii mouse-ului.
...The Width Tool was primarily designed for the "tablet" workflow, so you will get the great experience by using it with the tablet stylus. It is similar to making line thicker with a pencil or thinner with an eraser (if you holding the "Ctrl").
- NOTE: The Width Tool intended to fine-tune line width. If you want to heavily increase/decrease the line width its better to use the Normal Tool to directly manipulate the width ducks.
Parameters:
- Growth - Defines how much a single mouse move will affect the line width. It must be non-zero to have this tool make effect on bline.
- Radius - Defines the size of area around current cursor position in which vertex will be affected. It is allows you not to follow the line directly with a mouse to have a noticeable effect. It's fine to try Width Tool on blines with lots of segments (use Instrumentul de desenare - Draw Tool to create those), you will see it works on more than just the first vertex. It is a full circular area, other points may distract it though.
- Relative Growth - Doesn't really work very well unless the "Radius" parameter is set to some huge value (like a million).
If you don't want Width Ducks to be displayed, during usage of the Width Tool, just turn them off by pressing Alt+5. You can turn them on again with the same keybinding.
